IP Address (These 4 sections can be set in Netility as well. NetAgent will reboot after any of the above are changed.)

IP Address

This section is to set NetAgent IP address.

Subnet Mask

This section is to set NetAgent Subnet Mask.

Gateway

This section is to set NetAgent Gateway.

Obtain an IP address

This section is to choose to set NetAgent IP address manually or via DHCP.

DNS Server IP

Primary DNS Server IP

This section is to set NetAgent primary DNS Server IP address.

Secondary DNS Server IP

This section is to set NetAgent secondary DNS Server IP address. NetAgent will use the secondary DNS Server IP address when the Primary DNS Server IP address is not working.

Ethernet

Connection Type

This section is to set communication speed between NetAgent and Network. NetAgent will reboot after Connection Type is changed.

Stop UPS communication when Ethernet disconnected

This section is to set if stop UPS communication when NetAgent disconnects with Ethernet.

Dynamic DNS (This is a free service that allows the user to alias a dynamic IP address to a static hostname.)

Services Provider

NetAgent can be configured to register with any of the Dynamic DNS providers. In general, to register a Domain Name; a. Go to the DDNS provider website listed. b. Register a new user account and password with the DDNS provider. c. Choose a Domain Name to point to your current Dynamic IP. d. Enter information obtained in (b) and (c) into NetAgent DDNS fields.

Domain Name

This is the Domain Name you have created from the above selected DDNS provider.

Login Name

This is the Login / Account name that you have created with the selected DDNS provider.

Login Password

Enter the Password you have assigned to your DDNS Account.

Use external STUN server to get Public IP to register

Choose Yes to ensure that NetAgent uses the WAN / Public IP to update the selected DDNS server.

PPPoE (System will reboot if any configuration applies.)

Use this option to allow NetAgent to connect to the Internet directly using your xDSL modem. Once set-up, NetAgent will connect directly to the Internet without going through a router. The LCD will display the current WAN / Public IP instead of the LAN IP Address.

When Connection should be made

This is to set if use PPPoE to connect with NetAgent UPS. Disabled: Default setting. Connect always: NetAgent will automatically dial up and maintain continuous connection.

Login Name

Enter the login name assigned by your ISP.

Login Password

Enter the password assigned by your ISP.

This page is to set NetAgent Network settings.