UPS Testing

10 Second Test

This section is to show the UPS power status. The abnormal status will be displayed in red when there is a power event.

Deep Battery Test for _ minute(s)

This is to test if battery works normally.

Test until Battery capacity below _%

This function is to set a battery test to the pre-configured %.

Test Until Battery Low

This function is to execute until battery low.

Cancel Test

This is to stop any self test that executed.

Miscellaneous

Turn off UPS when AC failed/Reboot UPS

Selecting ' Turn off UPS when AC failed' will turn off the UPS. You can reboot the UPS by selecting ' Reboot UPS'.

Put UPS in Sleep mode for __ minutes/Wake up UPS

When the UPS is put into Sleep mode, it will not provide power. The UPS will provide power again after Sleep mode time is complete.

Reboot UPS

When execute such command, UPS load would start over.

Wake Up UPS

This function is to start up the UPS.

UPS Buzzer On/Off

This is to turn on/ off the UPS buzzer.

This page is to provide remote UPS test functions. Choose the test item, then click on 'Apply' to execute it. (Please refer to the UPS manual for individual UPS Test functions.) If you are using a Contact Closure UPS, you will only be able to use the function ' Turn off UPS when AC Failed'.